Skip to content

Guide · 16 November 2026

How do you protect floors, walls and lifts during a furniture install?

Protection goes down before the first piece comes through, along the whole route rather than in the rooms. What gets protected, with what, and who is responsible for laying it.

Protecting a site during a furniture install means covering the whole route before the first piece comes through: floor protection from the vehicle to each room, corner and door frame protection at every turn, blankets or panels in the lift, and cover on stair treads, nosings and balustrades. Protection laid after a job has started is laid in the wrong places, because furniture marks a building at the pinch points on the route rather than in the room it is going into.

The finished surfaces in a new or refurbished interior are usually the most recently completed and the most expensive things in the building, and furniture is the last thing to be carried across them. Nothing else on the programme has that combination.

Protection is also the step most often skipped under time pressure, because it costs a quiet half hour at the start of a day when the vehicle is already there and everybody wants to begin. The marks it would have prevented turn up in the final hour.

What gets protected, and with what

Hard floors take a rigid or semi rigid cover that will not creep underfoot, taped at its own joins rather than to the floor finish. Timber and stone want a breathable layer rather than plastic sheet, which holds moisture against a new finish. Carpet and rugs want a surface that sheds no fibres and leaves no adhesive, and are often better lifted than walked over in work boots.

Then the vertical surfaces, which take most of the contact. Door frames, architraves and reveals, internal and external corners at every turn on the route, stair balustrades and newel posts, and the wall at the height a carried piece sits. Lifts take blankets or panels on the walls, floor and door jambs, and in a managed building that lift protection is frequently fitted by the building itself.

Protect the route, not the room

Walk the route before anything comes in and mark every point where a piece has to be tilted, turned or set down. Those points are where protection earns its place: a stair return, a corridor corner, a threshold strip, a doorway narrower than the piece. A room with a protected floor and an unprotected doorway is not a protected room.

Set down points matter as much as the route itself. A piece that has to be re-gripped halfway needs somewhere flat and covered to rest on, and without one it gets rested against a wall. Leave the protection down until the last piece is in and the packaging is out, because the trip that marks a floor is usually a trip carrying cardboard rather than furniture.

Who is responsible for protection

Agree it in writing before the day, because it falls between parties more often than any other item on an install. On a construction site there may already be base build protection down, which covers the structure but not the finished surfaces a furniture route crosses. In an occupied home or a completed apartment there is usually nothing down at all.

Establish who supplies and lays the protection, who removes and disposes of it afterwards, and whether the building sets its own requirements for the lift and the common areas. Then establish the condition record: photographs of floors, walls and lift on arrival and again at the end, so a mark that was there before the furniture does not get attributed to the furniture.

Related services

A conversation, then a proposal.

Every proposal starts with understanding your business: what you move, how much, how often.